Nissan R200 Differential Crown Wheel & Pinion Final Drive Gear Set

We have a wide range of good used Nissan Differential Final Drive Gear Sets available.

These have been checked and condition of these parts are close to new.

We typically supply the Pinion & Crown Wheel with bolts to fasten the crown wheel.

 (Sometimes you will find 12mm bolts and or 13mm bolts on the crown wheel, this makes no difference if you run the smaller bolts on a LSD with larger bolt holes, but if your LSD has 12mm holes and your final drive we supply runs 13mm bolts you will need to drill the LSD bolt holes to 13mm.)

At times, we may include the bearings & shims to go with the pinion if we have not removed them. THIS IS NOT ALWAYS PROVIDED,PLEASE CHECK IF WE HAVE THEM AVAILABLE WITH THE RATIO YOU REQUIRE.
 
Be mindful, you can email us or enquire about if the gearset you require has the bearings on the pinion, this bearing also comes in various different sizes so in most cases it may not work in your housing anyway.

We suggest an experienced professional do the installation, as they need to set pinion height, backlash, fit shims and bearings to suit. 

Some ratios require different LSD's to offset your half shafts in the correct position, be mindful, there is allot of variables when you change ratios, however it's possible to make any ratio fit in any housing if you have the right knowledge on this subject.

ALL OF THESE GEARSETS ARE INTERCHANGABLE IN MOST R200 HOUSINGS FOUND IN THE SKYLINE,SILVIA,CEFIRO,LAUREL, ETC. THEY DO NOT FIT R200V from the Z33 & Z34.

If you would like to know the tooth count on the crown and pinion on a specific ratio, please send us an email or message and we will reply back with the information.